I would not use these parts they did not fit properly. The pins in my door are two different lengths so if you are showing your car cutting one would be a solution but the pin diameter is not correct (too small). After installation the door actuall was worse off than before I changed it. I had to take my door off due to an accident so I thought I would replace the pin and bushing but after grinding the old one down and pounding it out with quite a bit of effort I had of course ruined the old pin and bushing so I had no choice but to put this one on. It has way too much slack. The door now moves up and down by 1/4 inch at the trailing edge making it impossible to get good gaps.